This set of mounting brackets are longer than the MB-2-320 brackets and are for when gates are flush with the
back of the post.
They come with base plates ready to be bolted or screwed to a gate and its post. Suitable for use with King
Couper, Nice Wingo 4024 and Centsys Vert-X Swing Gate Motors. The brackets are for use with posts from
100mm square metal or timber to wider concrete or square brick posts. The hinges with this style of gate would
normally be a ball bearing or similar type mounted flushed to the back of the post and gate. The brackets a all
made from zinc plated steel.
The Gate Mounting Bracket (GMB) can be bolted to aluminium or timber
gates or self drilling screws can be used for steel framed gates.
When the Post Mounting Bracket (PMB) is fitted hard up against the hinge
edge of the post the gate will open up to 96 degs allowing 200mm space
behind a gate that opens against a fence or wall. Only four of the six holes in
the base plate or the PMB need to be used to firmly fix the PMB to the post
preferably with bolts through the post. Hole plugs are supplied to fill in the
unused holes.
To Next Page
Loading...
Need help?
General
