CBOX1050
Installation and Programming Manual
3434
support.hysecurity.com
20
DELETING SINGLE REMOTE CONTROL
A Nice remote control that has been programmed to control a Nice OXIBD/A receiver may be removed from
the receiver memory without aecting other assigned remote controls as follows:
1. Press and hold the button on the side of the Nice receiver (on 1050 board) until the LED on the Nice
receiver illuminates green and keep the button pressed. The LED will illuminate after approximately 4
seconds.
2. Press and hold any button on the Nice remote control until the LED on the Nice receiver blinks 5 green
ashes
3. Release the button on the side of the Nice receiver.
4. It is recommended to verify that the non programmed Nice remote control no longer controls the gate.
21
DELETING ALL REMOTE CONTROLS
All programmed remote controls may be removed from the Nice OXIBD/A receiver memory as follows:
1. Press and hold the button on the side of the Nice OXIBD/A receiver module until the green LED on the
receiver lights up and keep the button pressed.
2. Watch the LED and on the receiver and verify the following sequence in the LED:
a) Within 4 seconds after pressing the button (approx.) the green LED illuminates.
b) Within 8 seconds after pressing the button (approx.) the green LED turns o.
c) Within 12 seconds after pressing the button (approx.) the green LED starts ashing
3. Count the green LED ashes on the Nice receiver. On EXACTLY the 3
rd
ash, release the button on
the Nice receiver.
4. It is recommended to test the Nice remote controls, if available, with Nice OXIBD/A plug-in receiver to
verify that it no longer aects the gate controller.
To Next Page
Loading...
General