CBOX1050
Installation and Programming Manual
3636
support.hysecurity.com
Refer to FIGURE 22-1 on previous page for image of 1050 control board layout, LED indicators, and
controls. Menus and parameters are accessed and selected by pressing the buttons on the 1050 control
board as shown in Table 22-1:
Navigation buttons are used as follows:
22
CONTROL BOARD MENU NAVIGATION
1. Press desired option button. Option menu name appears in top half of display. Sub-option names and
parameter values appear in the lower half of display.
2. Press UP and DOWN buttons to navigate between options or values.
3. Press OK to select options to change or to accept selected values.
4. Each menu features an ESC selection for exiting the menu.
TABLE 22-1: 1050 CONTROL BOARD BUTTON FUNCTIONS
BUTTON FUNCTION
OPEN Button Opens the gate.
STOP Button Stops the gate, whether opening or closing.
CLOSE Button Closes the gate.
UP Button Used for navigating through menus, options, and values.
DOWN Button Used for navigating through menus, options, and values.
OK Button Selects the current menu, option, or value shown in the display.
RESET Button Resets a hard shutdown.
SPEED
1. Max :100
OK
1050 CONTROL BOARD MENU FLOW CHART LEGEND
SYMBOL MEANING SYMBOL MEANING
Generic 1050 Button LCD Display (default values in red)
Push OK Button Menu Flow Direction
Push UP Button Use UP & DOWN arrows to select
Push DOWN Button
NOTICE
The following pages illustrate and map the menu selection options in the 1050 control board.
To Next Page
Loading...
General