Nice CBOX1050 User Manual

CBOX1050
Installation and Programming Manual
3737
MX4682 Rev. D ©2021
FORCE BUTTON MENU:
Amount of force needed to cause the gate to stop
and reverse when hitting an obstacle.
• STATIC: Set sensitivity to constant force on a
scale of 1 to 10 (1 being the most sensitive).
• DYNAMIC: Set sensitivity of sudden impact
force to the moving gate on a scale of 1 to 10
(1 being most sensitive). 0 = OFF.
• EXIT: Exits the FORCE menu.
FORCE
1.Stac :5
FORCE
2.Dynamic :5
FORCE
3.ESC
FORCE
EXIT
(min-max
sensivity)
(min-max
sensivity)
(Low
to High)
OK
Press
SPEED
1. Max :100
SPEED
2. Standard :100
SPEED
3. Low :50
SPEED
4. SlowDown :50
ACCELERATION
5. Max :10
ACCELERATION
6. Standard :5
ACCELERATION
7. ESC
SPEED
EXIT
Press
OK
SPEED BUTTON MENU:
Sets the speed of the gate under various conditions.
• MAX: Sets limit of max allowed gate speed on scale of 20%
to 100% (20% is lowest setting). It is recommended to set to
default of 100.
• STANDARD: Sets limit of the gate speed during normal
movement (not soft start/stop) on scale of 20% to 100%
(20% being the lowest setting). It is recommended to set to
default of 100.
• LOW: Sets limit of the gate speed while in LEARNING mode
and when moving in SLOW, on scale of 20% to 100% (20%
being the lowest setting). Recommended not to be set lower
than 50. Default setting depends upon learning parameters
• SLOWDOWN: Set gate speed when approaching the open or
close limits on scale of 20% to 100% (20% being the lowest
setting). Recommended not to set lower than 50% for slide
gates. The lower this setting the less power the operator will
have when approaching the limit. Setting too low could cause
a stall condition prior to open/close limit.
» ACCELERATION: Adjusts the rate of acceleration/
deceleration when the motor starts and stops moving:
» MAX: Sets the limit of gate acceleration and
deceleration when reversing the gate after
an obstacle has been detected by
the UL/Edge or current sense feature
(Force). Settings from 3 to 10, with 10 being the highest
rate of gate acceleration.
» STANDARD: Sets the limit of the gate acceleration and
deceleration in normal operation. Settings from 1 to
10, with 10 being the highest rate of gate acceleration.
* *TO PREVENT DAMAGE TO THE GATE OR THE
CONTROLLER USE LOWER ACCELERATION SETTINGS
FOR HEAVIER GATES.
» ESC: Exit the SPEED / ACCELERATION menus.
SPEED Button
FORCE Button
OK
20%
100%
OK
3
10
OK
1
10
OK
20%
100%
OK
20%
100%
OK
20%
100%
OK
1
10
OK
0
10

Nice CBOX1050 Specifications

General

Brand	Nice
Model	CBOX1050
Category	Enclosure
Language	English