CBOX1050
Installation and Programming Manual
4848
support.hysecurity.com
Motor 1 Motor 2
Primary Secondary
Motor 1 Motor 2
Secondary Primary
Remote Pri Sec
O
Remote Pri Sec
O (blinking)
Remote Pri Sec
On Primary
Esc
Power Fail Open
O
Power Fail Open
O
Motor 12V
On
Motor 12V
On
Encoder Bemf
O
Encoder Bemf
O
O
On
O
Secondary
O
On
O
On
Primary
On Secondary
Primary/Secondary
Secondary/Primary
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
UL Input
Digital NO (blink)
UL Input
Digital NO (blinking)
UL Input
10K Res Both (blinking)
Digital
Digital
NC
From Inputs
(see previous page)
10K Res.
10K Res.
NO
OK
OK
OK
OK
OK
FUNCTION Button / Adv. Settings (Cont.)
FUNCTION>ADVANCE SETTINGS MENU (Cont.):
’ UL INPUT: For analog, select both, open, or close. For digial, select NC (normally closed) or NO (normally open).
’ SELECT PRIMARY / SECONDARY: Motor1 or Motor2
’ ACTIVATE LINK FOR REMOTE PRIMARY/SECONDARY: Enables control of an additional gate operator board.
’ POWER FAIL OPEN: Opens gate automatically on battery backup power if main AC power input loss is detected.
’ MOTOR 12V: Forces motor control voltage to +12VDC even if the supply voltage varies +9.5VDC up to +35VDC)
’ SET VIRTUAL ENCODER: For motors without built-in encoders.
Both
Open
Close
10. Default (see next page)
NOTICE
When set to 10K RES OPEN, CLOSE, or 10K RES BOTH, input must have an 8.2k-10k Ohm terminated
external entrapment sensor installed. 10K RES BOTH only available for Swing Gates.
To Next Page
Loading...
General