2
PRODUCT SPECIFICATION
Fan4-Control is a Z-Wave (800 series) enabled device for indoor temperature control. It is mainly applied to a 4-pipe Fan coil system. It can
read room temperature, and automatically control fan speed based on the temperature difference. This product can be included and operated
in any of Nice hubs equipped with Z-wave radio: Yubii Home, Yubii Home Pro or FIBARO Home Center 3 Lite and Home Center 3.
Table A1 Specifications
Power Supply AC85~260V, 50/60Hz
Resistive Load: ≤3A
Self Consumption: ≤1W
Temperature Sensor: NTC 10K
Temperature Range: 0~55°C
Temperature Setting: 5-37°C (Adjustable)
Humidity Range: <95% RH (Non-condensation)
Dimension: 86* 86*14mm
Hole Pitch: 60-65mm (60 or 86 Standard junction box)
Z-Wave Frequency: Operating frequency range, defined by the regulatory bodies
(for Z-wave in Europe: 868.4 MHz, or other regions 908.4/916.0 MHz , 921.4 MHz)
Over Current Protection: Required external 10A circuit breaker
1
WARNINGS AND GENERAL PRECAUTIONS
• CAUTION! – Read the instructions before starting up the unit!
• CAUTION! – This product is not a toy. Keep out of reach of children and animals!
• CAUTION! – Do not expose the device to moisture, water or other liquids. Do not place liquids near or on the device!
• CAUTION! – Do not attempt to disassemble, repair or modify the device yourself!
• CAUTION! – This product is for indoor use only. Do not use outdoors!
• CAUTION! – Flush-mount only into a UL/ETL/CE certified plastic junction box. The minimum size should be 65*65*45mm,
minimum Volume is 190cm3. Use Copper Conductors Only.
• CAUTION! – Risk of Electric Shock - More than one disconnect switch may be required to de-energize
the equipment before servicing.
To Next Page
Loading...
Need help?
General