Nice NDA001 - Maintenance

TABLE 6: DIAGNOSTICS of bluebus devices
PARAMETER DESCRIPTION
Bluebus
PHOTOCELLS
PHOTO Indicates whether the photocell is present, the relative operating status and
the correct memorisation in the control unit.
PHOTO II Indicates whether the photocell is present, the relative operating status and
the correct memorisation in the control unit.
PHOTO 1 Indicates whether the photocell is present, the relative operating status and
the correct memorisation in the control unit.
PHOTO 1 II Indicates whether the photocell is present, the relative operating status and
the correct memorisation in the control unit.
PHOTO 2 Indicates whether the photocell is present, the relative operating status and
the correct memorisation in the control unit.
PHOTO 2 II Indicates whether the photocell is present, the relative operating status and
the correct memorisation in the control unit.
PHOTO 3 Indicates whether the photocell is present, the relative operating status and
the correct memorisation in the control unit.
FT A Indicates whether the sensitive edge is present, the relative operating status
and the correct memorisation in the control unit.
FT B Indicates whether the sensitive edge is present, the relative operating status
and the correct memorisation in the control unit.
FT C Indicates whether the sensitive edge is present, the relative operating status
and the correct memorisation in the control unit.
OPEN PHOTO Indicates whether the control photocell is present, the relative operating status
and the correct memorisation in the control unit.
OPEN PHOTO II Indicates whether the control photocell is present, the relative operating status
and the correct memorisation in the control unit.
COMMANDS:
CMD 1 Indicates whether the control photocell is present, the relative operating status
and the correct memorisation in the control unit.
CMD 2 Indicates whether the control photocell is present, the relative operating status
and the correct memorisation in the control unit.
CMD 3 Indicates whether the control photocell is present, the relative operating status
and the correct memorisation in the control unit.
CMD 4 Indicates whether the control photocell is present, the relative operating status
and the correct memorisation in the control unit.
CMD 5 (SEM1) Indicates whether the “trafc light 1” control device and whether it is memo-
rised correctly in the control unit.
CMD 6 (SEM2) Indicates whether the “trafc light 2” control device and whether it is memo-
rised correctly in the control unit.
OTHER:
GATE Indicates the operating status of the application.
BLOCK AUTOMATION Indicates when the automation is blocked following a “Block” command.
MEMORY Indicates a problem regarding the data related to bluebus devices, memo-
rised in the control unit.
BUS Indicates whether there is a short circuit on the bluebus output.
STAND-BY Indicates when the control unit is in standby status.
OTHER DEVICES:
COURTESY LIGHT Indicates whether the control device is present, the relative operating status
and whether it is memorised correctly in the control unit.
SUCTION CUP Indicates whether the control device is present, the relative operating status
and whether it is memorised correctly in the control unit.
LOCK Indicates whether the control device is present, the relative operating status
and whether it is memorised correctly in the control unit.
TRAFFIC LIGHTS:
TRAFFIC LIGHT 1 Indicates the operating status of the device.
TRAFFIC LIGHT 2 Indicates the operating status of the device.
MAINTENANCE
Manual alarm threshold
A value from 0 to 16777215 (manoeuvres) can be assigned to this parameter; the factory setting is 10000 (manoeuvres). This function enables programming
of a reference limit, over which automation maintenance is required.
Partial count
This function enables the user to check the number of manoeuvres performed by an automation since it was last serviced.
Delete maintenance
This parameter is ON/OFF; the factory setting is “OFF”. This function enables deletion of the “partial count” value; this is required after performing maintenance
on the automation.