Nice OXI User Manual

9 - English
EN
PROCEDURE 3 - Memorising a new transmitter “near the receiver”
01.
On the NEW transmitter: hold down the key to be memorised;
wait at least 7 seconds then release it.
x 7 sec
1
3
2
4
1
2
1
NEW
02. On the transmitter ALREADY MEMORISED: press and re-
lease 3 times the memorised key to be copied.
1
3
2
4
1
2
1
OLD
03. On the NEW transmitter: press and release once the same key
pressed at step 01.
1
3
2
4
1
2
1
NEW
If there are other transmitters to be memorised, repeat the procedure from the beginning for each new
transmitter.
3.4 - Memorising a new transmitter using the “enabling code” of an old transmitter already memo-
rised in the receiver - only for transmitters with “O-Code” and “O-Code/A” encoding system
The memory of transmitters with “O-Code” and “O-Code/A” encoding contains an “enabling code” (secret)
which can be used to enable a new transmitter to be memorised in the receiver. To perform this enabling
procedure, read the transmitter’s instruction manual and get an old transmitter already memorised in the same
receiver in which the new transmitter is to be memorised. Warning! - The enabling code can only be transferred
between two transmitters that have the same radio coding.
Subsequently,whenthenewenabledtransmitterwillbeused,itwillsendtothereceiver(intherst20transmis-
sions)thecommand,itsownidenticationcodeandthe“enablingcode”received.Atthispoint,thereceiver
willrecognisetheenablingcodeoftheoldtransmitterandautomaticallymemorisetheidenticationcodeof
the new transmitter.
• The undesired memorisation of transmitters through the “enabling code” can be prevented by blocking the

Nice OXI Specifications

General

Brand	Nice
Model	OXI
Category	Receiver
Language	English