Nice OXI

EN
English - 10
receiver’s function through Procedure 6 (Paragraph 3.7). Alternatively, the receiver can be blocked also with the
O-Box programmer, by intervening on the receiver or on the transmitters already memorised.
3.5 - Deleting the receiver’s memory (fully or partially)
PROCEDURE 4 - FULL or PARTIAL deletion of the receiver’s memory
01.
On the receiver: hold down key A and observe the status of the
greenLEDB:after6 seconds it will light up then switch off. After
a few seconds it will start flashing; then immediately choose the
type of desired deletion:
1
2
> to delete ALL the transmitters: release key A exactly at the
3
rd
flash
1
2
> to delete ALL THE RECEIVER’S MEMORY: release key A
exactly at the 5
th
flash
1
2
This function can be performed also using the O-Box / O-View programmers.
3.6 - Deleting a SINGLE transmitter or a SINGLE key from the receiver memory
PROCEDURE 5 - Deleting a SINGLE transmitter or a SINGLE key from the receiver memory
01. On the receiver: hold down key A, observe the green
LEDBlightupandmovetostep02whenitswitchesoff.
1
2