To Next Page

To Previous Page

11 - English

02. On the transmitter to be deleted:

• (on the transmitter) hold down the key (*4) to be de-

letedandreleaseitafterLEDB(onthereceiver)has

emitted the 1

of 5 quick green flashes (= deletion

completed correctly).

(*4) Note - If the transmitter is memorised in “Mode 1”, any key can be pressed. If the transmitter is memo-

rised in “Mode 2”, the entire procedure must be repeated for each memorised key that must be deleted.

This operation can also be performed through the O-Box / O-View programmers.

3.7 - Locking (or release) of memorisations carried out with the “near the control unit” procedure

and/or through the “enabling code”

This function prevents the memorisation of new transmitters in the receiver, when using the “near the receiver”

procedure (Paragraph 3.3) or the “enabling code” procedure (Paragraph 3.4). The default setting is ON for both

procedures. To perform the following procedure it is necessary to have a transmitter already memorised in the

receiver.

PROCEDURE 6 -

Locking (or release) of memorisations carried out with the “near the control

unit” procedure and/or through the “enabling code”

01. Disconnect the power supply and wait 5 seconds.

OFF

5 s

Nice OXI User Manual

Questions and Answers: