Nice OXI User Manual

EN
English - 4
Verification of the TYPE OF ENCODING system adopted by the transmitters already memorised
01. Disconnect the power supply to the control unit then restore the
powersupplyandcountthenumberofashesemittedbyLEDB
on the receiver:
OFF
ON
•1greenash = transmitters with Flo encoding system
x 1
•2greenashes = transmitters with O-Code, O-Code/A or FloR,
FloR/A encoding system
x 2
•3greenashes = transmitters with Smilo encoding system
x 3
•5greenashes = no transmitter memorised
x 5
To change the coding assigned to the rstone-waytransmittermemorised, it is necessary to delete from the
memory all the transmitters present, by strictly adopting Procedure 4 (Paragraph 3.5) and choosing the option,
“ALLTHERECEIVERMEMORY”.
WARNINGS for carrying out the programming procedures
• During the execution of the programming procedures, refer to Fig. 1 to identify key
A and LEDB on the receiver. • To understand the meaning of the icons featured in the
procedure, refer to the table, “Key to the symbols used in the manual”. • The proce-
dures have a limit time; therefore, before implementing them, it is important to read and
understand all the steps to be completed.
1
2
AB
1

Nice OXI Specifications

General

Brand	Nice
Model	OXI
Category	Receiver
Language	English