To Next Page

To Previous Page

6 – English

h - manually open the gate leaf fully

i - place the rst section of the rack on the gearmotor’s

pinion: make sure that it corresponds to the start of the

gate leaf and that there is a gap of 1–2 mm between the

rack and the pinion (this so as to prevent the gate leaf

weight from bearing on the gearmotor)

1÷2 mm

l - secure the rack section

1÷2 mm

m - slide the gate by hand and, using the pinion as a ref-

erence, secure the other sections of the rack

1÷2 mm

Nice RD400 Instructions And Warnings For Installation And Use

Other manuals for Nice RD400