30
Display screensaver: sets the time after which the camera display
will power o (does not aect the recording of videos). The display
can then be activated again by touching the display or by pressing
the camera’s control buttons.
Language: language settings for the in-camera menu.
Date format: date format settings for captured videos and photos.
Date: date settings.
Time: time settings.
Time stamp: the date and time may be inserted into videos and
photos.
Frequency: frequency settings (50 Hz for Europe, 60 Hz for USA)
Format: erases all data located on the memory card.
Factory settings: reset the camera to its factory settings.
Firmware: information regarding the camera’s rmware.
WATERTIGHTNESS
The camera is watertight only when paired with its watertight case,
and may only be submerged in water under the following conditions:
The case is watertight to the depth of 30 meters. Before using the
camera in its case, ensure that the case’s rear door has been closed
correctly with the help of the mechanism located on the upper side
of the case. The small door and gaskets much be completely rid of
any foreign materials such as dust, sand, and the like. If the case has
been used in salt water, wash the case o with fresh water. Do not
use any textile materials or external heat sources to dry the camera
(fans, microwave ovens, etc.), always let the case slowly dry out on
its own. The camera’s touch screen display may not be used when
the watertight case is also in use, meaning the camera may only be
controlled via the buttons.
Warning: the camera is not watertight without its case! Use only the
original case to ensure the watertightness of the camera.
To Next Page
Loading...
