7600RF RF Receiver [Preliminary] User’s Manual
In Virtual KeyPad Object usually
setting the entire control algorithm
and working together with
SwitchCtrl network variable value.
ctrlCMDn.limitMin
Setting value of process button message id minimal id
ctrlCMDn.limitMax
Setting value of process button message id maximal id.
ctrlCMDn.ctrlType
Setting what kind of process will to do. When V_SwitchCtrl received
a data from another LonWorks device(s).
About ctrl_Type enumerate list as following shown.
UCPTswValTable UCPTswValTable is for all the Switch
Value Table define.
Responsible when UCPTkeyPadCP
value assign to ctrl_CMD, and
ctrl_Type of ctrl_CMD equal to
Ctrl_PresetInex reference value.
All of the value data are store in this
property.
ctrl_Type enumerate list
Name of enumerate Description
Ctrl_NOP Nothing to do.
When V_SwitchCtrl network variable received data value.
Ctrl_PresetValue Direct pass value.
When V_SwitchCtrl network variable received data value to
V_Switch network variable. It’s for output purpose.
Usually, in 5006L programming model first Virtual KeyPad Object
should setting on this.
Ctrl_ PresetIndex Get value from index table.
The UCPTswValTable configure property is an index table for
Ctrl_ PresetIndex parameter.
If selected Ctrl_ PresetIndex and then you have to setting all the
value in the UCPTswValTable configure property.
Ctrl_InactiveSw Setting button as an Inactive (Off status) command.
When button was release. (also call this for Off status).
18
Rev.1.0B
To Next Page