7600RF RF Receiver [Preliminary] User’s Manual
Usually, Ctrl_InactiveSw working together with Ctrl_ActiveSw.
If selected Ctrl_InactiveSw and then you have to setting a value
in inactiveSw.value item and then value of inactiveSw.value will
output to V_Switch network variable.
Ctrl_ActiveSw Setting button as an Active (On status) command.
When button was press. (also call this for On status)
Usually, Ctrl_InactiveSw working together with Ctrl_ InactiveSw.
If selected Ctrl_InactiveSw and then you have to setting a value
in activeSw.value item and then value of activeSw.value will
output to V_Switch network variable.
Ctrl_DecValue Setting button as a Decrease value command.
When button was press, how many decrease value will output to
V_Switch network variable.
Usually, Ctrl_DecValue working together with Ctrl_IncValue item.
If selected Ctrl_DecValue and then you have to setting a value in
decSwVal item.
Ctrl_IncValue Setting button as a Increase value command.
When button was press, how many increase value will output to
V_Switch network variable.
Usually, Ctrl_IncValue working together with Ctrl_DecValue item.
If selected Ctrl_IncValue and then you have to setting a value in
incSwVal item.
Collection all of above explain its can found the category of configure rule as
following:
1. Single button to present an On/Off status. This is a Toggle functional button.
[Notion of configure]
Setting value of ctrl_CMDn.ctrl_ctrlType equal to Ctrl_ActiveSw or
Ctrl_InactiveSw and then setting value of activeSw.value or inactiveSw.value
item.
2. Single button to present a setting status. This is a Setting functional button.
[Notion of configure]
Setting value of ctrl_CMDn.ctrl_ctrlType equal to Ctrl_ActiveSw and then
19
Rev.1.0B
To Next Page