Nidec Commander C300 - Removal of the Size 7, 8 and 9 A Internal EMC Filter and Line to Ground Varistors (Size 7 Shown)

78 Unidrive M / HS Frame 7 to 10 Power Installation Guide
Figure 4-13 Removal of the size 7, 8 and 9A internal EMC filter and line to ground varistors (size 7
shown)
To electrically disconnect the Internal EMC filter, remove the screw as highlighted above (1).
To electrically disconnect the line to ground varistors, remove the screw as highlighted above (2).
The Internal EMC filter on size 9E and 10E cannot be removed.
The supply must be disconnected before removing the internal EMC filter.
WARNING
1
2
NOTE