Nidec Unidrive HS72 - User Manual

Control Getting Started
Guide
Unidrive M702
Unidrive HS72
Part Number: 0478-0251-04
Issue: 4

Nidec Unidrive HS72 Specifications

General

Brand	Nidec
Model	Unidrive HS72
Category	DC Drives
Language	English

Summary

Safety Information

Warnings, Cautions and Notes

Essential information for avoiding safety hazards and equipment damage.

Important Safety Information, Hazards, Competence of Designers and Installers

Covers hazards, safe operation, and installer competence.

Electrical Hazards

Details risks of severe shock and burns from drive voltages.

Stored Electrical Charge

Explains the risk of lethal voltage from stored charge after power disconnection.

Mechanical Hazards

Addresses hazards from drive functions and the need for risk analysis.

Motor

Adjusting Parameters

Introduction

Operating Modes

Describes the different operational modes the drive supports.

RFC-A Mode

RFC-S

Control Connections

Position Feedback Connections

Details connections for position feedback devices via the 15-way D-type connector.

Position Feedback Connection Details

Communications Connections

Getting Started

Quick Start Commissioning; Start-up Using Unidrive M Connect

Guide to using Unidrive M Connect software for initial setup.

Keypad; Display

Explanation of the drive's keypad layout and display functionalities.

Keypad Operation

Control Buttons

Menu 0

Changing the Operating Mode

Saving Parameters

Restoring Parameter Defaults

Parameter Access Level and Security

NV Media Card Operation

Transferring Data

Basic Parameters (Menu 0)

Parameter Descriptions

Detailed descriptions of basic parameters available in Menu 0.

Pr mm.000

Running the Motor

Quick Start Connections

Basic Requirements

Quick Start Commissioning; Start-up

Step-by-step guide for initial commissioning and start-up procedures.

Open Loop

Commissioning steps for the Open Loop operating mode.

RFC-A Mode (with Position Feedback)

Commissioning steps for RFC-A mode with induction motors and feedback.

RFC-A Mode (Sensorless Control)

Commissioning steps for RFC-A mode with sensorless induction motors.

RFC-S Mode (with Position Feedback)

Commissioning steps for RFC-S mode with permanent magnet motors and feedback.

RFC-S Mode (Sensorless)

Commissioning steps for RFC-S mode with sensorless permanent magnet motors.

Use of the Motor Database for a Leroy Somer LSRPM Motor