Nidec Control Techniques Digitax-SF DA23823 - Page 247


Digitax SF Instruction Manual
6. Operation
3. Velocity Control Mode
Precautions for Testing
Testing Procedure
Before applying power to each drive or motor, be
sure that all wiring has been performed properly.
Set the parameters correctly before testing.
Check motor motion rst with no machine connected.
For a brake-equipped motor, be sure to disengage the brake
before operating the motor.
Step Operation
Step 1

Step 2
drive
Step 3
AC Supplydrive
Step 4

Step 5



Step 6
correct direction


