Nidec NE300-4T2000G/2200P-U - Page 100

NE200/300 Series Drive User Manual
Chapter 5 List of Parameters 91
Code Description Setting range Default Modify
Modbus
Address
Fd.07
Communication
interrupt
detection mode
0: Time interval
between 2 packets
receiving.
1: Time interval of
0005H Add. data
writing
0 ○ 0E07H
Fd.08
Feedback or
not (Y or N)
While writing
into COMMS
setting
0 ： Y
1 ： N
0 ○ 0E08H
Fd.09
Save the
COMMS
setting or not
(Y or N)
While power
down
0 ： N
1 ： Y
0 ○ 0E09H
Group FE: Operation interface & display
Code Description Setting range Default Modify
Modbus
Address
FE.00
Display
parameter-type
setup
0: Normal 3-levels menu
display
0 ○ 0F00H
1: Only display modified
parameters
FE.01
MFK Key
function
selection
0: MFK inactive
0 ○ 0F01H
1: JOG running
2: FWD/REV switching
3: UP/DOWN clear
4: Running command
switch (terminal or
communication)
7: RUN for FWD, MFK
for REV, STOP for
STOP
FE.02
STOP key
function
0: Valid only in keypad
control mode
2 ○ 0F02H
1: Valid in stop state of
terminal/ communication