SI-Ethernet User Guide 197
Issue: 3
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Tools
Applications
Security Diagnostics
Glossary of
terms
Index
For writable parameters, to write a new value, enter the new value and click 'Submit'. The new
value will be written to the specified parameter.
Some parameters will provide a drop-down box from which the desired option may be selected;
parameters designated as bit parameters will provide a tick box to represent the desired state of the
parameter (Off or On).
If the parameter state is currently 'On' then the tick box will be greyed out.
If the parameter state is currently 'Off' then the tick box will be highlighted.
To change the parameter state, click the tick box and then click the 'Submit' button.
The Parameter Editor page also provides buttons to reset the drive and save the parameters in the
drive.
7.6.8 User timeout
There is a user timeout facility where the user will be logged out after a period of 5 minutes of
inactivity unless the current web page is refreshed or data is updated on a page. In this situation,
the web page will still indicate the user is logged in but, upon activating any web page, will then
prompt the user to sign in.
To Next Page
Loading...
