52 SI-Ethernet User Guide
Issue: 3
This parameter is used to enable or disable the Easy Mode protocol interface.
This parameter is used to perform a warm reset of the Easy Mode protocol interface. When set and
the protocol has reset, the parameter will be reset to zero (Off).
This parameter allows the protocol to be defaulted to factory settings. This includes all of the
protocol features, configuration, mappings and stored objects.
This parameter displays the total number of cyclic (Rx and Tx) messages per second.
S.10.001 Easy Mode Enable
Minimum 0
(Display: Off)
Maximum 1
(Display: On)
Default
1
(Display: On)
Units None
Type 1 Bit User Save Update Rate Background read
Display Format None Decimal Places 0
Coding RW, BU
S.10.002 Easy Mode Reset
Minimum 0
(Display: Off)
Maximum 1
(Display: On)
Default
0
(Display: Off)
Units None
Type 1 Bit Volatile Update Rate Background read
Display Format None Decimal Places 0
Coding RW, NC
S.10.003 Easy Mode Default
Minimum 0
(Display: Off)
Maximum 1
(Display: On)
Default
0
(Display: Off)
Units None
Type 1 Bit Volatile Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, NC
S.10.004 Cyclic Messages Per Second
Minimum 0 Maximum 65535
Default None Units Messages/s
Type 16 Bit Volatile Update Rate Background
Display Format None Decimal Places 0
Coding RW, BU, PT, NC, ND
To Next Page
Loading...
