Non-volatile media card data transfer
Details of the data that can be stored on a non-volatile media card and the methods to transfer/access this data are given in Menu 11.
Stored HF trips
When the drive is subsequently powered up a StoredHF trip is initiated where the sub-trip number is the number of the HF trip that last occurred. This
trip will occur at every power-up until it is reset. The trip can only be reset by first entering 1299 into Parametermm.000 (mm.000). If the drive is
powered up and a StoredHF trip occurs, OnboardUserProgram:Enable (Pr 11.047) is reset to zero to prevent the on-board user program from
running. This ensures that the user program can be changed or erased in case it causes an HF trip at every power-up. Once the StoredHF is cleared, it
is necessary to power cycle the drive or to re-download the user program to allow the program to restart.
To Next Page
Loading...
Need help?
General
