Nieco JF94E - Cleaning Stripper Blade and Chain Shafts

22
Nieco Corporation - Model JF94E CE
1. Tilt stripper blade away from chain; lift off
brackets.
Make sure stripper blade is cool before putting in
water or it may warp.
2. Take to sink area and spray with degreaser.
3. Wash with a scrub pad, rinse, and sanitize in the
3-compartment sink.
REASSEMBLY: Hang stripper blade on brackets.
Stripper Blade - P/N 18919
Discharge End
Tools
Instructions
C
lean: Daily
3-Compartment Sink
Scrub Pad
Heat Resistant Gloves
Degreaser
!
1. Scrape each shaft of both belts on the discharge
end with the wide end of the shaft cleaning tool.
The tool is located on the clip on main side control
box.
2. Wipe shaft cleaning tool with a towel.
Chain Shafts
Discharge End
Tools
Instructions
Clean: Daily
Shaft Cleaning
Tool P/N 9128