What to do if Nightfox CORSAC 2 powers on briefly or not at all?
If the unit powers on briefly or not at all, the battery power might be insufficient. Plug the unit in and let it charge, even if nothing appears on the screen. After an hour, try turning it on again.
Why Nightfox Corsac 2 Monocular LCD screen does not display image at night?
The LCD screen may not display an image at night due to several reasons: * The lens cap might still be in place. Remove the lens cap from the left-hand lens, as it contains an IR filter intended for daytime use only. * The IR level might be set to 0. Increase the IR level by pressing the ?/ + button in Video or Photo mode. * There might be insufficient ambient light if you're using it covertly without IR. Check the location's ambient lighting. * Insufficient battery power for high IR usage. High IR settings consume more battery. Try reducing the IR level by pressing the ?/ - button in Video or Photo mode, or plug the unit in to charge.
What to do if Nightfox Corsac 2 Monocular picture is out of focus?
If the picture appears out of focus, it might be that the manual focus wheel hasn't been adjusted. To sharpen the image, simply rotate the focus wheel located on the left-hand side of the unit.
General| Objective lens diameter | 25 mm |
|---|---|
| Refresh rate | 50 Hz |
| Eye Relief | 15 mm |
| Waterproof | Yes |
| Fogproof | Yes |
| Lens Coating | Fully multi-coated |
| Prism Type | Roof |
| Tripod Adaptable | Yes |
Explains the function of the Power, Mode (M), and brightness (+/-) buttons on the device.
Details on Format, Auto Power Off, Date Stamp, Date/Time, Frequency, and Version settings.
Troubleshooting steps for no display at night or undetected IR light.
Resolving 'Please format the card' errors and card compatibility issues.
Solutions for images that are out of focus.
To Next Page
