NIKKARI SSET - Adjustment of Edging Depth

25
■OperatingMethod
● Align the edging position with the blade, and slowly move forward while edging.
● The wheel must always be touching the ground during the work.
■Prohibited Matter
● Do not hold the edger on your left side.
Note
● This edger is designed for the operation with
it held on the right side of the operator.
● Do not operate holding the edger higher than your
ankle.
● Do not move backward while edging.
4.6 Adjustment of Edging Depth
Before/after the edging work, make sure that the knob bolt for adjusting the
height of the wheel is tightened.
* Otherwise, the knob bolt can become loose during use, which could cause the height of
the wheel to be changed suddenly, resulting in injury.
Loosen the height adjustment knob [1].
Move the wheel [2] up/down to adjust
the height of the blade [3] from the
ground.
Tighten the height adjustment knob [1].
[1]
[2]
[3]
1
2
3