NIKKARI SSET - 7 Waste Disposal; 8 Troubleshooting

33
7. Waste Disposal
For disposal, observe the standards and regulations of your region. If there is any question, contact your
servicing dealer.
8. Troubleshooting
In case of failure, follow the table below.
When troubleshooting, stop the engine and then remove the attachment from
the powerhead.
* Iftheenginestartsduringthework,handsorngerscouldbeseveredbythemoving
parts or blade.
Situation Possible Cause Correction
Output is not enough. Throttle cable adjustment is
faulty
Refer to the powerhead manual.
Engine concern.
Refer to the powerhead manual.
Vibration is too large. Poor balance of attachment
Contact your servicing dealer.
Improper-installation of
attachment
Check the installed status.
Tighten attach nut.
Looseness of connection of
attachment
Contact your servicing dealer.
Shaft tube is bent.
Contact your servicing dealer.
Blade is cracked or broken. Contact your servicing dealer.
Blade is dull Blade has concern. Bring to your servicing dealer for
regrinding or purchase a new blade.
Blade does not move even
if the engine speed is
increased.
Gear has worn. Contact your servicing dealer.
Debris is wrapped around blade
or shaft.
Remove debris.
Wheel does not rotate
smoothly
Foreign objects are caught
inside.
Refer to “5.3.2 Cleaning of wheel”.