05-201
54
Error detection
When an error occurs, an ‘!’ will appear on the display.
The error code can be viewed in the ‘Check error’ menu item.
1. Briey press
and select the menu item.
2. Briey press
in order to check and note down the error code.
3. Briey press
in order to delete the error, return to the main
screen.
Error #2: internal error, memory
Error #3: shortcircuit on the Nikobus B1’ B2’
Error #5: no voltage on the Nikobus B1 B2
Error #6: no voltage on the Nikobus B1’ B2’
Error #7:successively receiving 3 incorrect SMS messages.
The main owner (mobile phone number 1) receives message: ”Warning 3 times wrong
sms received by your sms module at home! Possible attempt to break in!”
Memory function - Memory
If logical connections have already been programmed in the PC-Logic, these can be temporarily
switched off so that they will not generate a bus telegram. This is used if more sensors or
push buttons have been installed after installation and programming,
and you wish to call up the addresses via the software.
1. Briey press
and select the menu item.
2. Briey press
in order to make the selection.
3. Briey press
, the memory is switched off, return to the main
screen.
GB
[ SHECK ERROR ]
Memory
SHECK ERROR
No error [ >]
[ MEMORY ]
Set inputs
MEMORY
OFF [ >]
M 1 2 3 4 5 6
_ _ _ _ _ _
To Next Page
Loading...
Need help?
General
