25
s
4
Attach a lens.
Be careful to prevent dust from entering the camera when the
lens or body cap is removed.
5
Turn the camera on.
Press the power switch to turn the
camera on. The power lamp will
briefly light green and the monitor will
turn on. Be sure to remove the lens
cap before shooting.
Check the battery level and number of
exposures remaining in the monitor
(0 17).
Keeping marks aligned, position lens on
camera, then rotate until it clicks into place.
Mounting mark
(camera)
Mounting mark (lens)
Mounting mark (lens)
Battery level
Exposures remaining
To Next Page
Loading...
