137
i
Load from/Save to Card
Custom Picture Controls created using the Picture Control Utility
available with ViewNX 2 or optional software such as
Capture NX 2 can be copied to a memory card and loaded into
the camera, or custom Picture Controls created with the camera
can be copied to the memory card to be used in other
Nikon 1 V1 cameras and compatible software and then deleted
when no longer needed.
To copy custom Picture Controls to or from the memory card, or
to delete custom Picture Controls from the memory card, select
Load from/save to card in the Custom Picture Control menu.
The following options will be displayed:
Copy to camera
Copy custom Picture Controls from the memory card to
custom Picture Controls C-1 through C-9.
Delete from card
Delete selected custom Picture
Controls from the memory
card. The confirmation dialog
shown at right will be dis-
played before a Picture Control
is deleted; to delete the
selected Picture Control, high-
light Ye s and press J.
Copy to card
Copy a custom Picture Control (C-1 through C-9) to a
selected destination (1 through 99) on the memory card.
A
Copy to Card
Up to 99 custom Picture Controls can be stored on the memory card at
any one time. The memory card can only be used to store user-created
custom Picture Controls. The preset Picture Controls supplied with the
camera can not be copied to the memory card or deleted.
A
Custom Picture Control > Delete
The Delete option in the Custom Picture Control menu can be used to
delete selected custom Picture Controls when they are no longer
needed.
To Next Page
Loading...
Need help?
General
