En
17
Attaching Bayonet Hood HB-23
Align the index ( ) on the hood with the lens hood mounting index on the
lens, and turn the hood counterclockwise (as viewed from the camera) until it
click stops at the index ( ).
To facilitate attachment or removal of the hood, hold it by its base rather than its
outer edge. To store the lens hood, you can attach it in the reverse position.
Lens Care
•Clean the lens surface with a blower brush. To remove dirt and smudges, use a
soft, clean cotton cloth or lens tissue moistened with ethanol (alcohol) or lens
cleaner. Wipe in a circular motion from center to outer edge, taking care not to
leave traces or touch other parts.
•Never use thinner or benzene to clean the lens as this might damage the lens,
result in a fire, or cause health problems.
•To protect the front lens element, an NC filter is recommended at all times. A
lens hood also helps protect the front of the lens.
•When storing the lens in the lens case, attach both front and rear caps.
•When the lens will not be used for a long time, store it in a cool, dry place to
prevent mold. Also store the lens away from direct sunlight or chemicals such
as camphor or naphthalene.
•Do not get water on the lens or drop it in water as this will cause it to rust and
malfunction.
•Reinforced plastic is used for some parts of the lens. To avoid damage, never
leave the lens in an excessively hot place.
Supplied Accessories
77mm snap-on front lens cap
Rear lens cap
Bayonet hood HB-23
Hard Case CL-76
Optional Accessories
77mm screw-in filters
To Next Page
Loading...
Need help?
General
