Upgrading the Coolpix 5700 Firmware
— Windows —
Thank you for choosing a Nikon product. This guide describes how to
upgrade the camera firmware for the Coolpix 5700.
Get ready
To upgrade the firmware for the Coolpix 5700, you will need:
• A Coolpix 5700 digital camera
• A UC-E1 USB cable
OR a CompactFlash card reader
• One of the following power sources:
— An EH-53 AC adapter
OR an EH-21 AC adapter/battery charger
— A fully-charged EN-EL1 rechargeable battery
— A fresh 2CR5 (DL245) battery manufactured in the last three months
• A Nikon-approved CompactFlash memory card that has been formatted in the Coolpix 5700
•
The
Nikon Guide to Digital
Photography for the
Coolpix 5700
Check the current firmware version for the Coolpix 5700
1
Open the camera monitor.
2
Press and hold the (MENU)
button while turning the camera on.
3
“E5700 V” will be displayed in the monitor, followed by the
version number of the current camera firmware.
If the monitor shows “E5700 V1.0,” the current camera firmware
is version 1.0. This upgrade can be used with firmware version
1.0 and should not be applied to any other versions.
To Next Page
