77
More on Playback
Connecting the USB Cable
Turn the computer on and wait for it to start up. After confi rming that the
camera is off, connect the UC-E6 USB cable as shown below. Connect the
camera directly to the computer; do not connect the cable via a USB hub or
keyboard.
Windows 2000 Professional, Windows Millennium Edition (Me),
Windows 98 Second Edition (SE)
Do NOT select PTP when connecting the camera to a computer running one of the above
operating systems. If the camera is connected to a computer running one of the above
operating systems with PTP selected in the USB menu, the Windows hardware wizard
will be displayed. Click Cancel to exit the wizard and then disconnect the camera. Be
sure to select Mass storage before reconnecting the camera.
When the camera is turned on, the lens will extend and will be displayed
in the control panel. All controls except the power switch will be inactive.
Connecting the USB Cable
The camera digital I / O connector is on a slight angle.
Match this angle when connecting the USB cable.
UC-E6 USB cable
Downloaded From camera-usermanual.com Nikon Manuals
To Next Page
Loading...
