Storage
Turn tile camera off when not in use.(heck that tile power<x] lamp isoff before
putting tile camera away. Remove tile batteries if the camera will not be used for
an extended period. Do not store tile camera with naphtha or camphor moth
balls, or in any of the following locations:
• Next to equipment that produces strong electromagnetic: fields, such as
televisions or radios
• Exposed to temperatures below -10 °C (14 °F)or above 50 °C (122 °F)
• Poorly ventilated or subject to humidities of over 60 %
To prevent mold or mildew, take tile camera out of storage at least once a monfl].
Turn the camera on and release tile shutter a few times before putting tile camera
away again.
Notes on the Monitor
• The monitor may contain a few pixeB that are always bitor that do not bight, This is a characteristic
common to all TFT LCD displays, and does not indicate a malfunction, images recorded using the
product will not be affected.
• When framing bright subjects, vertical comet like streaks that whiten toward either end may
appear in the display. This phenomenon, known as "smear," does not indicate a malfunction.
in shooting modes other than movie mode, smear has no effect on the images that are recorded.
• images in the monitor may be difficult to see under bright lighting.
• The monitor is bit by an LED backlight. Should the monitor begin to dim or flicker, contact your
Nikon authorized service representative.
r_
F,"
m
z
709
To Next Page
Loading...
