75
Recording Movies
Recording and Playing Back Movies
B Recording Movies
• Memory cards with an SD Speed Class rating of 6 or faster are recommended when recording
movies (A19). Movie recording may stop unexpectedly when memory cards with a lower Speed
Class ratings are used.
• When Electronic VR (A83) is set to Auto in the setup menu, the angle of view (the area
captured in the recorded movie) is smaller than when taking still images.
• Optical zoom cannot be adjusted once movie recording begins.
• Rotate the zoom control during recording to enable digital zoom. Subjects can be magnified up to
4× the optical zoom ratio applied before movie recording began.
• There is some degradation in image quality when digital zoom is used. When recording ends,
digital zoom turns off.
• In some cases, movie recordings may capture the sounds of the camera, such as the sounds
produced by the zoom control operation, the movement of the lens during autofocus, or the
aperture control when the brightness changes.
• Smear (F 3) visible in the monitor with movie recording will be recorded with movies. Avoiding
bright objects such as the sun, reflections of the sun, and electric lights when recording movies is
recommended.
• When recording or playing back movies, colored stripes (interference patterns or moiré) may
appear on subjects that have a regular, repeating grid, such as pattern of weave in cloths or
windows in a building, depending on the shooting distance or zoom ratio. This phenomenon
occurs when the subject’s pattern interferes with the camera sensor grid, and it does not indicate
a malfunction.
B Note About Autofocus for Movie Recording
When shooting a subject that is not suitable for autofocus (A29), the camera may not be able to
focus properly on the subject. Follow the procedure below if you are trying to shoot this type of
subject for movies.
1. Set Autofocus mode in the movie menu to A Single AF (default setting) before starting
movie recording.
2. Frame a different subject (positioned at the same distance from the camera as the intended
subject) in the center of the frame, press the b (e movie-record) button to start recording, and
modify the composition.
B Note About Camera Temperature
• The camera temperature may increase significantly when used for
an extended period of time for movie recording, etc. or when
used in places with high ambient temperature.
• If the camera becomes extremely hot while recording a movie,
the camera automatically terminates recording after 30 seconds.
The camera monitor displays the number of seconds (B30s)
remaining until automatic termination is activated.
Five seconds after movie recording is terminated, the camera
turns off. Wait until the internal temperature decreases before using it again.
To Next Page
Loading...
Need help?
General
