15
Inserting the Battery
First Steps
Removing the Battery
Turn the camera off before removing the battery.
To eject the battery, open the battery-chamber/
memory card slot cover and slide the battery latch
in the direction shown (1). The battery can then be
removed by hand (2).
• Note that the battery may become hot during
use; observe due caution when removing the
battery.
Turning On and Off the Camera
To turn on the camera, press the power switch. The
power-on lamp will light and the monitor will turn
on. To turn off the camera, press the power switch
again.
If the camera is turned off, press o for about a
second to turn the camera on in playback mode (c 28).
j Note on the Battery
Be sure to read the warnings for the battery on page ii and “Caring for the Camera” (c 131)
to make use of this camera.
To Next Page
Loading...
Need help?
General
