Nikon D800E - Page 397

373
n
A Recognizing CPU and Type G and D Lenses
CPU lenses (particularly types G and D) are recommended, but note that
IX-NIKKOR lenses can not be used. CPU lenses can be identified by the
presence of CPU contacts, type G and D lenses by a letter on the lens
barrel.
Type G lenses are not equipped with a lens aperture ring.
A The AF-S/AF-I Teleconverter
The AF-S/AF-I teleconverter can be used with the following AF-S and
AF-I lenses:
• AF-S NIKKOR 70–200mm f/2.8G ED VR II
• AF-S VR 70–200mm f/2.8G ED
• AF-S 80–200mm f/2.8D ED
• AF-S VR Micro-Nikkor 105mm f/2.8G
IF-ED
1
• AF-S NIKKOR 200mm f/2G ED VR II
• AF-S VR 200mm f/2G ED
• AF-S NIKKOR 200–400mm f/4G ED
VR II
2
• AF-S VR 200–400mm f/4G ED
2
• AF-S NIKKOR 300mm f/2.8G ED VR II
• AF-S VR 300mm f/2.8G ED
• AF-S 300mm f/2.8D ED II
• AF-S 300mm f/2.8D ED
• AF-I 300mm f/2.8D ED
• AF-S 300mm f/4D ED
2
• AF-S NIKKOR 400mm f/2.8G ED VR
• AF-S 400mm f/2.8D ED II
• AF-S 400mm f/2.8D ED
• AF-I 400mm f/2.8D ED
• AF-S NIKKOR 500mm f/4G ED VR
2
• AF-S 500mm f/4D ED II
2
• AF-S 500mm f/4D ED
2
• AF-I 500mm f/4D ED
2
• AF-S NIKKOR 600mm f/4G ED VR
2
• AF-S 600mm f/4D ED II
2
• AF-S 600mm f/4D ED
2
• AF-I 600mm f/4D ED
2
1 Autofocus not supported.
2 Autofocus and electronic
rangefinding support focus
points shown at right when
used with TC-17E II, TC-20E II, or TC-20E III AF-S teleconverters.
When used
with TC-20E II/TC-20E III, focus data for focus points other than the center focus
point are obtained from line sensors.
Single point AF is used when 3D-
tracking or auto-area AF is selected for AF-area mode (0 93); at maximum or
combined apertures slower than f/5.6, the camera may not be able to focus on
dark or low-contrast subjects.
Aperture ring
CPU lens Type G lens Type D lens
CPU contacts
TC-17E II
TC-20E II/
TC-20E III