P(
10) From the Setup menu, use “Setup > Image setup” to get into the dialogue boxes to adjust
image.
a. Select “modify” in Setups dialogue box.
b. Select Exposure dialogue box and make sure “auto” is selected. It should also
be set to:
8-bit for
grayscale
24-bit for color
no binning
c. Select “auto”. This brings up
another dialogue box.
Adjustment: use this to adjust image
brightness: lower # is darker image.
Gain: This is usually set at “1” for BF or DIC imaging.
11) Select Post-Processing dialogue box. Adjust gamma (lower # adds contrast to image).
You should see the flatfield box checked.
12) Proceed to take your image. Modify Adjustment and Gamma if necessary to get a
satisfactory image.
To Next Page
Loading...
