156
Accessory shoe/Sync terminal/Ready-light
• Accessory shoe
• An optional Speedlight such as the SB-800, SB-600, SB-80DX, SB-50DX, SB-30,
SB-29s/29, SB-28/28DX, SB-27, SB-26, SB-25, SB-24, SB-23 or SB-22s can be
attached directly to the accessory shoe of the F6 without a cord. This accessory
shoe is equipped with a safety lock that prevents accidental drop when a
Speedlight having a safety-lock pin (SB-800, SB-600, SB-80DX, SB-30, SB-29s/29,
SB-28/28DX, SB-27, SB-26, SB-25 or SB-22s) is attached.
• Sync terminal
• To use a Speedlight that requires a sync cord, attach one end of the sync cord to
the sync terminal.
When performing rear-curtain sync with a Speedlight such as SB-800, SB-600,
SB-80DX, SB-50DX, SB-28/28DX, SB-27, SB-26, SB-25 or SB-24 attached to the F6’s
accessory shoe, do not attach a additional Speedlight via the sync terminal.
• Ready-light
• When using a Speedlight such as the SB-800, SB-600, SB-80DX, SB-50DX, SB-30,
SB-29s/29, SB-28/28DX, SB-27, SB-26, SB-25, SB-24, SB-23 or SB-22s, the ready-
light fi lights up when the Speedlight is fully charged and ready to fire.
• If the ready-light blinks approx. 3 sec. after full flash output (when the Speedlight is
set to TTL, Auto Aperture flash or Non-TTL Auto flash mode), underexposure may
have occurred. Check the focus distance, aperture or flash shooting distance range
and shoot again.
P930_En 04.10.19 7:19 PM Page 156
To Next Page
Loading...
