50
Autofocus—continued
•Selecting focus area
The F6’s 11 focus areas cover a broad range, and you can select
among them depending on the subject’s position in the frame or
your desired composition. They provide a sharp, reliable focus
without requiring that you use focus lock (x 58).
1
Set the AF Area mode selector to a position
other than j.
• When j is selected, multi-selector is locked
and focus area cannot be selected.
2
Rotate the multi-selector lock release to
release the lock and press the multi-selector
to select a focus area.
• Select a single focus area in Single Area AF or
Dynamic AF modes, or a group of focus areas
in Group Dynamic AF Mode.
• To change the focus area(s), lightly press the
shutter release button and press the multi-
selector up/down/right/left in the appropriate
direction. (To select the center focus area[s],
press the center of the multi-selector.)
• Selected focus area(s) appear(s) momentarily in
red in the viewfinder.
• Selected focus area(s) is/are also indicated in
the rear LCD panel (in normal and detailed
display).
Display in single area AF mode
P930_En 04.10.19 7:18 PM Page 50
To Next Page
Loading...
