FLASHPHOTOGRAPHY------------------------------
~
The N2000 accessory shoe allows direct mounting of Nikon
dedicated electronic flash units.
When the N2000
is
set at
A,
P,
P
HI
, or a manual setting of
1/
250 sec. or higher, shutter speed automatically switches to
1/125 sec. for proper flash synchronization. When the N2000
is
set at a manual setting of 1/125 sec. or slower, shutter operates
at the speed set
on
the·dial.
Ready-light indication
in
the viewfinder
is
also provided with
Nikon dedicated flash units. With the camera's meter
on,
a
thunderbolt-mark
LED
ready-light comes
on
to indicate the flash
is
ready to fire. Warning indications are provided by a blinking
ready-light. Conditions represented by the warning vary between
flash unit models. For details, see your flash unit instruction
manual.
Use Nikon Speedlights only. Other units may damage the
camera's electrical circuit.
26
Nikon
Speed
light
Connection Usable Flash
Mode
programmed TTL
S8-15/S8-1681
Direct
auto·, TTL auto,
S8-18
non-TTL auto,
manual
Via
TTL
Remote
Programmed
TTL
auto·,
TTL
auto,
Cord
SC-23
manual
S8-11/S8-14
Via
Sensor Remote
Non-TTL auto,
Cord
SC
-13
manual
S8-16A/S8-17
Via Flash Unit Non-TTL auto,
Coupler
AS-6
manual
• Programmed TTL auto fla
sh
photography can only be performed with
AI·S type Nlkkor and Nikon Se
ri
es E lenses. For information on how
to recognize
AI-S t
yp
e lenses refer to page
36.
The
following instructions are for programmed
TTL
auto and
TTL
auto flash shooting only. For non-TTL auto
and
manual flash
shooting, see your flash unit instruction manual.
Note that the film speed range for programmed TTL auto
and TTL auto flash photography
is
ISO
25
to
1000
.
To Next Page
Loading...
Need help?
General
