Nikon SB-16 - Mode Selector

C-15. S~t .Iens to the
minimum aperture
(largest f·number).
C-16. Set the S8·16's
mode selector
to TTL.
17.
I
I I I ( I ( I
2 MD M [ffD
.n.r-
II
For TTL operation
• •
( I () (, (
Al A2 MD
.n
II
For automatic
operation (A2)
Turn on the flash
unit.
Slide the S8-16's ON /O FF switch to
the right. Immediately, an LED w il l light
up (green LED for TTL operation, or
red
A1 or A2 LED for automatic
operation).
Note : The LED may blink fo r a short while after
the flash unit is turned
on. This does not indicate
a malfunction.
17