Nikon SC - Microscope Assembly; Eyepiece Tube and Eyepiece Attachment; Stage and Objective Mounting

II. ASSEMBLY
Before handling the microscope, remove the red-
colored lock screw. (Fig. 4)
1. Attaching the eyepiece tube (Fig. 5)
i; Slacken the eyepiece tube clamp screw suf¬
ficiently.
2) Tilting the eyepiece tube as ^own in Fig. 5,
seat it in a horizontal position.
3) Fasten up the clamp screw securely.
2. Attaching the eyepiece (Fig. 6)
1) Remove the dust caps from the tubes.
2 ) Screw in the eyepieces.
3; To avoid accidental release, screw the eye¬
piece in firmly, using a rubber sheet or the
like to hold the eyepiece.
3. Attaching the mechanical stage (Fig. 7)
1} Place the mechanical stage on the stage
mount so that the travel knobs are on the
right side of an operator facing the stage.
2) Fasten the stage from the bottom with the
two 4mm hexagonal hole bolts, using tool A.
4. Attaching the objectives (Fig. 8)
1) Screw the objectives into the revolving nose-
piece in such order that, as the nosepiece is
rotated clockwise, an objective of higher
magnifying power enters the optical path.
2) For avoiding accidental release, it is possible
to lock them tightly using tool C,
Eyepiece tube clamp screw
Tool C
Mechanical
stage
Travel
knobs
Revolvmg
nosepiece
6