nilan VPL 25 - Preset

This document may be subject to change Side 20 of 23
Preset
” ” indicates that the menu point flashes and can be set to another value
Use of t he CTS 600 panel :
- pr ess ESC t o go one st ep back i n t he menu
- pr ess qpt o move up or down i n a menu or t o
adj ust an act i vat ed menu
- pr ess ENTER t o act i vat e a menu
- pr ess ENTER t o conf i r m a menu
- pr ess OFF t o t ur n of f t he uni t
- pr ess ON t o t ur n t he uni t on
HEATING
AIR
EXCHANGE
DEFROST
INLET
CONTROL
SERVICE
ENTER
TEMP.
CONTROL
MANUAL
OFF
ROOM
CONTROL
RESTART
OFF
PRESET
OFF
ENTER
PRESET
”OFF”
PRESET
”STANDARD”
When ”standard” is
chosen all factory
settings are reset. An
eventual supplementary
heating surface must be
re-activated.
A heating surface is NOT
frost-protected until it is
correctly installed and
activated in the service
menu.
SURFACE
Figure 15: The "Preset" menu