What to do if there is a Detergent Pump driver fault in my Nilfisk-Advance Scrubber?
If the Detergent Pump driver for your Nilfisk-Advance Scrubber is reporting a fault due to over-current or over-temperature, you should replace the Detergent Pump driver IC.
What should I do if there's a Deck Actuator driver fault in my Nilfisk-Advance Scrubber?
If the Deck Actuator driver in your Nilfisk-Advance Scrubber is reporting a fault due to over-current or over-temperature, consider replacing the Deck Actuator driver IC.
How to fix a Speed Control fault on a Nilfisk-Advance Scrubber?
If your Nilfisk-Advance Scrubber displays a Speed Control fault, it means the E1 Curtis Speed Controller is communicating a problem to the A1 Control Board. You can try to resolve this by resetting the E1 Curtis Speed Controller.
What causes a Detergent Pump driver to stay on in a Nilfisk-Advance Scrubber?
If the Detergent Pump driver on your Nilfisk-Advance Scrubber is stuck on, meaning the measured current was above the minimum when it should have been off, investigate the Detergent Pump driver for any issues.
What causes Scrub Deck Actuator overload in Nilfisk-Advance Scrubber?
If the Scrub Deck Actuator on your Nilfisk-Advance Scrubber has an overload, it means the actuator has drawn more than 4.5 amps. To resolve this, check the actuator for mechanical binding or excessive load.
What to do if the Solution Solenoid has an overload in my Nilfisk-Advance Scrubber?
If the Solution Solenoid Valve in your Nilfisk-Advance Scrubber has an overload, it means it has drawn more than approximately 1 amp. Inspect the Solution Solenoid Valve for blockage.
Why is my Nilfisk-Advance Scrubber's Detergent Pump overloading?
If the Detergent Pump in your Nilfisk-Advance Scrubber experiences an overload, meaning it has drawn more than approximately 1 amp, inspect the detergent pump for blockages.
Why is the Vacuum Contactor driver stuck on in my Nilfisk-Advance Scrubber?
If the Vacuum Contactor driver on your Nilfisk-Advance Scrubber is stuck on, and the measured current was above the minimum when it should have been off, check the Vacuum Contactor driver wiring.
What causes the Brush Contactor driver to be stuck on in a Nilfisk-Advance Scrubber?
If the Brush Contactor driver on your Nilfisk-Advance Scrubber is stuck on, and the measured current was above the minimum when it should have been off, inspect the Brush Contactor driver for faults.
What should I do if the Brush Contactor has coil overload in my Nilfisk-Advance Scrubber?
If the Brush Contactor on your Nilfisk-Advance Scrubber experiences a coil overload, and it has drawn more than approximately 1 amp, examine the brush motor for issues such as binding.
General| Brand | Nilfisk-Advance |
|---|---|
| Model | Advance SC1500-X20R |
| Category | Scrubber |
| Language | English |
Covers essential safety precautions, warnings, and operational guidelines.
Outlines daily, weekly, monthly, and yearly maintenance tasks.
Explains key switch, emergency stop, horn, speed, scrub, and solution controls.
Guides on diagnosing faults using codes and tables.
Accessing and using the service test mode for diagnostics.
Details speed control functions and communication between controllers.
Guides on diagnosing traction system issues using various methods.
To Next Page