3/2019 A - 9 56091217 - SC901 ST
ENGLISH - AINSTRUCTIONS FOR USE
BATTERIES
If your machine shipped with batteries installed do the following:
Check that the batteries are connected to the machine (15).
Turn ON the Key Switch (A) and check the Battery / Hour Gauge (F). Battery Charge capacity is indicated using a 10 segment LED bar
graph display from full (right LED segment lit) to empty (left LED segment lit). LED Flash Alert™ fl ashes the 2nd LED from the left as a
warning that the battery has discharged 70%.
At 80% discharge, LED Flash Alert™ alternately fl ashes the left 2 LEDs to indicate very low capacity is remaining. At this level the scrub
systems are disabled to protect the battery. The vacuum system will continue to operate to allow recovery of any solution remaining on fl oor.
IMPORTANT!: BATTERIES SHOULD BE FULLY CHARGED BEFORE EACH USE. SEE THE “CHARGING THE BATTERIES”
SECTION.
IMPORTANT!: IF YOUR MACHINE HAS AN ONBOARD BATTERY CHARGER REFER TO THE OEM PRODUCT MANUAL FOR
INSTRUCTIONS REGARDING SETTING THE CHARGER FOR BATTERY TYPE.
If your machine shipped without batteries installed do the following:
Consult your Authorized Advance dealer for recommended batteries.
Install the batteries by following the instructions below.
DO NOT install three 12 volt batteries in your machine. This affects the stability of the machine.
IMPORTANT!: IF YOUR MACHINE HAS AN ONBOARD BATTERY CHARGER REFER TO THE OEM PRODUCT MANUAL FOR
INSTRUCTIONS REGARDING SETTING THE CHARGER FOR BATTERY TYPE.
WARNING!
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin
or eyes. Explosive hydrogen gas is vented from the batteries through openings in the battery caps. This gas can be ignited by
any electrical arc, spark or fl ame. Do not install any lead-acid battery in a sealed container or enclosure. Hydrogen gas from
overcharging must be allowed to escape.
When Servicing Batteries...
* Remove all jewelry
* Do not smoke
* Wear safety glasses, rubber gloves and a rubber apron
* Work in a well-ventilated area
* Do not allow tools to touch more than one battery terminal at a time
* ALWAYS disconnect the negative (ground) cable fi rst when replacing batteries to prevent sparks.
* ALWAYS connect the negative cable last when installing batteries.
CAUTION!
Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Advance, a
qualifi ed electrician, or the battery manufacturer should install batteries.
When changing batteries or the charger, please contact your local authorized service center for correct battery, charger and machine
settings to prevent battery damage.
To Next Page
Loading...
Need help?
General
