ELECTRICAL SYSTEM
FORM NO. 56043088 / Advenger
™
/ BR 600S, 650S, 700S, 800S - 59
Solution Switch (R):
This switch is used to toggle the state of the solution solenoid. Pressing and releasing this switch will alternately turn the solution solenoid on and
off. The indicator (Q) provides the following status information:
Off - Solenoid output is off.
Green - Solenoid output is on.
Flashing Red – Solution solenoid / contactor coil overload has occurred.
Horn Switch (N):
This switch is used to momentarily activate either the scrub deck lift actuator or the squeegee lift actuator. See the descriptions above for more
details.
Fast / Slow Switch (L):
This switch is used to toggle the state of the multimode output to the speed control. This is used to select which speed limit the speed control
uses. Pressing and releasing this switch will alternately turn the multimode output on and off. The indicator (M) provides the following status
information:
Steady Green – Speed control mode 1 is selected (transport speed).
Brief Off Green Flash – Speed control mode 2 is selected (scrub speed).
Wand Switch (I):
This switch does not control any output functions. Pressing this switch will illuminate the wand indicator.
SERVICE TEST MODE (CONTINUED)
To Next Page
Loading...
