To Next PageTo Next PageWhat to do if Nilfisk-Advance Floor Machine wheel drive works in one direction only?
If the wheel drive on your Nilfisk-Advance Floor Machine only works in one direction, you should repair the wiring or replace the R1 pot and replace the (A1) speed control.
Why won't the wheel drive motor run in forward and reverse on my Nilfisk-Advance Floor Machine?
Several factors can prevent the wheel drive motor from running in both directions. Here's what to check: * **Batteries:** Ensure they are fully charged and recharge if necessary. * **Circuit Breakers:** Look for tripped breakers, specifically the Wheel Drive Motor Circuit Breaker (F2) and the Control Circuit Breaker (F4), and reset them. * **Parking Brake:** Make sure the parking brake is released. * **Emergency Stop Switch:** Verify the Emergency Stop Switch (13) is not tripped; reconnect the battery to reset it. * **Safety Switch:** Check the Safety Switch (S2) in the seat to confirm it's closed. * **Motor:** The Wheel Drive Motor might be defective and need replacement. * **Throttle Potentiometer:** A defective Throttle Potentiometer (R1) may also be the cause, requiring ...
General| Brand | Nilfisk-Advance |
|---|---|
| Model | Advenger 2600D |
| Category | Floor Machine |
| Language | English |
Explains safety symbols and provides general operating/servicing safety guidelines.
Checklists for operational/visual inspections with defect codes.
Explanation of control panel layout, buttons, and operational functions.
Description of control panel indicators, hourmeter, and battery status meanings.
Explains the wheel drive system, controller, and operational modes.
Details on speed selector circuit, pin key, and troubleshooting common issues.
Guide for diagnosing scrub brush system faults and error codes.
Covers battery specifications, charger requirements, installation, charging, maintenance, and testing.
Actuator adjustment, controller diagnostics, fault codes, and installation checkout.
Overview, troubleshooting, error codes, and service test mode for the main control board.
Programming options for scrub modes, pressure, vacuum, delays, and alarms.
