Nilfisk-Advance BA 430 User Manual (English)

Other manuals for Nilfisk-Advance BA 430

Questions and Answers:

K
Karina WellsAug 1, 2025
Why is there poor water pickup with my Nilfisk-Advance BA 430?
- J
  Jaime ChristianAug 2, 2025
  Poor water pickup in your Nilfisk-Advance Floor Machine can occur due to several reasons: * The recovery tank might be full, causing the float shut-off to close. In this case, you should check and empty the recovery tank. * There might be blockages in the vacuum system, specifically the squeegee hose and float cage. Clear any blockages present. * Vacuum hoses could be disconnected or damaged. Inspect and repair or replace any faulty hoses. * The squeegee blades might be worn or damaged. Check the blades and replace them if needed. * The recovery tank cover may not be seated properly. Ensure it is correctly seated. * The recovery tank cover gasket could be damaged. Inspect and replace it if necessary.
M
Mr. Jason Jones IIAug 11, 2025
How to fix squeegee streaks on my Nilfisk-Advance Floor Machine?
- J
  jennifer20Aug 11, 2025
  Squeegee streaks on your Nilfisk-Advance Floor Machine can be resolved by addressing these potential issues: * Debris might be trapped under the squeegee blade. Remove any debris found there. * The squeegee blade may be worn, nicked, or torn. Replace the blade if it shows these signs. * Debris may have accumulated on the squeegee blade. Clean the blade to remove any buildup.
V
Vincent MillsAug 20, 2025
What to do if my Nilfisk-Advance Floor Machine leaves swirl marks?
- S
  Sherry NelsonAug 20, 2025
  Swirl marks from your Nilfisk-Advance Floor Machine can result from: * Running the machine with a dry brush or pad, without cleaning solution. Always ensure you use a wet brush or pad with cleaning solution. * Using the incorrect brush or pad for the application. Use the correct brush or pad suitable for the task. * Debris caught in the brush or pad. Remove any debris that may be trapped.

Nilfisk-Advance BA 430 Specifications

General

Model	BA 430
Category	Floor Machine
Battery Voltage	24 V
Noise Level	68 dB(A)
Power Source	Battery
Working Width	430 mm
Cleaning Path	430 mm
Battery Capacity	24 V
Brush Motor Power	0.5 kW