3
A
Safety Precautions
Warning!
Inhalation of aerosols can be hazardous to health. Where applicable use a device in order to
avoid or reduce aerosols production, e.g., a shield covering the nozzle. For protection against
aerosols use a respiratory mask of class FFP 2 or higher.
Always unplug the power plug before cleaning or maintenance and when replacing parts or
converting the machine to another function.
Observe the national safety regulations issued, for example, by the employers liability insur-
ance association, social security institutions, occupational safety and health authorities or oth-
er organizations.
Hold the spray lance firmly with both hands. The spray lance is affected by a thrust of up to
16,4N during operation.
The operator and anyone in the immediate vicinity of the site of cleaning should take action to
protect themselves from being struck by debris dislodged during operation. Wear goggles dur-
ing operation.
Disconnect from electrical power supply before carrying out user maintenance.
To ensure the appliance safety only use original spare parts from the manufacturer or ap-
proved by the manufacturer.
High pressure hoses, fittings and couplings are important for the safety of the appliance. Only
use hoses, fittings and couplings recommended by the manufacturer.
Do not use the appliance if a supply cord or important parts of appliance are damaged, e.g.
safety device, high pressure hose and trigger gun.
The appliance is only intended for cleaning outdoors.
Appropriate ear protection must be used.
Never use the machine in an environment where there could be a danger of explosion. If any
doubt arises, please contact the local authorities.
It is not allowed to clean asbestos containing surfaces with high pressure.
This high pressure washer must not be used at temperatures below 0°C.
Voltage and frequency of the machine (see rating plate) must match the voltage of and fre-
quency of the mains supply.
Only connect the machine to electrical installation made by a certifi ed electrician and com ply
with IEC 60364-1.
It is recommended that the electrical supply to the machine should include a residual current
device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms.
To Next Page
Loading...
Need help?
General
