SM_MC_6P Ver.2.0_2021
Safety instructions
4
A
For your own safety
ESD measures
(electrostatic discharge)
Observe valid safety regulations
for electrical equipment. In
particular, observe the following
regulations:
IEC 60335-2-79
EN 60335-2-79
Additionally:
Also see national regulations
Before using the cleaner, always
read the operating instructions
and keep them readily available.
Only allow the high pressure
Repair work should be carried
out by persons instructed in
electrical installations or by
trained electricians only.
Take the following ESD precautions before carrying out any
repairs to the electronics:
• Touch the earth conductor before repairing the cleaner
( to discharge electrostatic charge from your body ).
• Wear wrist band if necassary.
• Use a conductive floor covering or a conductive table cover.
• Never touch the printed circuit board or electronic components
( always hold on to plastic ).
• Transport electronic components in conductive packaging
( e.g. ESD bag ).
To Next Page
Loading...
